Wilton PF3-EZ Bedienungsanleitung

Operating Instructions and Parts Manual Powered Stock Feeder for Table Saws Model PF3-EZ WMH TOOL GROUP, Inc. 2420 Vantage Drive Elgin,

106. Tighten the screws firmly with a 19mm wrench. 7. Insert the pin assembly into the hole (Figure 2). You may need to rotate it until it seats pr

11 NOTE: The handle can be pivoted out of the way if necessary. Lift up on the handle, rotate the handle on its pin, then release the handle, making

12Extension Cords If an extension cord is necessary make sure the cord rating is suitable for the amperage listed on the machine's motor plate.

13Pivot To pivot the Stock Feeder (for maintenance, oil filling, etc.): 1. Loosen the handle (E, Figure 10) and pull up on the pin (F, Figure 10).

14General Operating Instructions 1. Make sure all locking handles are tight before operating the Stock Feeder. 2. The Stock Feeder should be used in

151. Loosen and remove the hex nut and flat washer on the roller shaft with a 24mm wrench. 2. Remove the outer roller. 3. Install a spacer on the

16Fill the oil reservoir about every 1,000 hours or six months, or sooner if needed. To fill with oil: 1. Pivot the Stock Feeder so that the rollers

17Troubleshooting Trouble Probable Cause Remedy Not connected to power source. Check plug connection. Fuse blown, or circuit breaker tripped. Repl

18Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848, Monday

19Parts List: Stand Assembly Index No. Part No. Description Size Qty 1... PF3EZ-101 ...Column Base...

2Warranty and Service WMH Tool Group, Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Servi

20Index No. Part No. Description Size Qty 58... PF3EZ-158 ...Rack ...

21Stand Assembly

22Parts List: PF3-EZ Feeder Index No. Part No. Description Size Qty 1...BB-6003...Bearing (#6003)...

23Index No. Part No. Description Size Qty 59...PF3EZ-259 ...Case Cap ...

24PF3-EZ Feeder

25Electrical Connections

26

27Boring Template SCALE 1:1

28 WMH Tool Group, Inc. 2420 Vantage Drive Elgin, Illinois 60124 Phone: 800-274-6848 www.powermatic.com www.wmhtoolgr

3Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on th

5 blahblahblah 21. Make your workshop child proof with padlocks, master switches or by removing starter keys. 22. Give your work undivided attention

6Introduction This manual is provided by WMH Tool Group, Inc. covering the safe operation and maintenance procedures for a Model PF3-EZ Stock Feeder.

7Features

8Unpacking Open shipping containers and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca

9Assembly Tools needed for assembly (not provided): Electric drill center punch and hammer 10.5mm drill bit M12 x P1.75 tap 12mm and 19mm wrenches 4m